Editor’s Tip: Cutting blinds might void the warranty, so consider this before you begin.
How to Cut Bamboo Blinds
Learn how to cut bamboo blinds to fit the windows in your home. Below are the supplies you’ll need.
Supplies Needed
Bamboo blinds Painters tape Measuring tape Permanent marker or fabric marker Miter saw Straight edge E6000 permanent adhesive glue Cutting mat Utility knife
How to Cut Bamboo Blinds That Are Too Wide
This quick DIY project will fix bamboo blinds that are too wide for your window.
Step 1: Roll Blinds
Roll the blinds tightly around the headrail, making sure the edges are even. Tape the rolled blinds in the center to hold them in place and stabilize them.
Step 2: Measure and Mark Intended Size
Measure and mark where you want to cut the blinds. You can reduce both sides or one. To reduce both sides, measure out from the center point an equal distance on each side. Reduce your measurement by 1/4 inch to allow the blinds to move within your window frame. Editor’s Tip: Once you’ve marked your measurements, you can choose to wrap additional painters tape around the bamboo blinds a few inches from each end. This will help with stability as you’re cutting.
Step 3: Cut Blinds
Cut the blinds at your measurements using a miter saw. Cut the headrail as well. Depending on your bamboo blinds and how much material you’re removing, you might have to cut a slot on the headrail or move the mounting bracket.
How to Cut Bamboo Shades That Are Too Long
Prevent your bamboo blinds from piling up on the windowsill with these simple steps.
Step 1: Mark Length
Install the blinds on the window according to the manufacturer’s instructions. Mark on the back of the shades your desired length. At full length, the blinds should sit just above the windowsill but shouldn’t touch the surface. Use a measuring tape and straight edge to draw a straight line across the back of the blinds at your mark.
Step 2: Cut and Tie Strings
Identify the closest ring above your mark and cut the string. Tie the string to the ring, double knotting and trimming the excess. Repeat, cutting and tying all the rings at the same level.
Step 3: Secure Strings
On the front of the blinds, find the area where you’re going to cut. Glue the strings above and below that point to prevent them from unraveling. Be sure to glue at every string across the entire length.
Step 4: Cut Final Length
Once the glue is dry, use a utility knife on a cutting mat to cut off the extra length. Fold about an inch of the bottom up and glue it to the back of the blinds to create a faux hem. Trim or tie the pull cords to shorten.
